. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Well tried a different PSU, nothing else running on the PC. Will build another PC tomorrow to try and rule that out.

  2. #2
    Quote Originally Posted by ngwagwa View Post
    Well tried a different PSU, nothing else running on the PC. Will build another PC tomorrow to try and rule that out.
    Have you checked the mechanicals.? Don't assume just because there's no play etc check them properly for binding because it doesn't take much on these low powered machines.

  3. #3
    Quote Originally Posted by JAZZCNC View Post
    Have you checked the mechanicals.? Don't assume just because there's no play etc check them properly for binding because it doesn't take much on these low powered machines.
    Will do in the morning, thanks.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Weird Mach3 + CSMIO/IP-M Probe Problem
    By matt-b2 in forum General Discussion
    Replies: 24
    Last Post: 11-07-2019, 01:05 PM
  2. Weird NC Studio behaviour after manual tool change
    By WRandall in forum Chinese Machines
    Replies: 1
    Last Post: 27-07-2018, 10:47 AM
  3. Losing steps on Z axis
    By Arzo10 in forum Machine Discussion
    Replies: 15
    Last Post: 31-03-2017, 10:49 AM
  4. weird z axis..
    By dazza in forum General Discussion
    Replies: 5
    Last Post: 10-11-2014, 01:39 AM
  5. New Mill losing steps
    By lukecnc2012 in forum Gantry/Router Machines & Building
    Replies: 42
    Last Post: 08-11-2014, 02:56 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •