Aluminium Profile Type Router - Initial questions

[JAZZCNC]

Cheers Jazz - will give it a once over and remember I actually need to grease it..
Ha, well I've managed to bend one bit so far - luckily a cheap one, but amazing how easily the 5.5Nm bends it like a twig..!
Maybe I'll give the Aztec a go in MDF first - does that count:)

Wait until 5.5Nm rips the material from the bed and throws across the room or you program 100 instead if 10 on a Z move and in blink of an eye it's punched a nice neat hole thru your bed(not that I've done this before.)

Regards Aztec and MDF then don't do a small one in MDF because it doesn't hold the detail good enough. You need a harder material that holds nice edge for smaller ones like 6" to get the full affect and see all the tiny details.