I was on a roll last night...

I put a z-0 setter on my table so I can use the table as my Z zero. Ran it and it worked fine... the. Put a piece of ply stock on my table and I usually hit “Return to Zero” to check that everything is set... but now my Z zero is one the top of the table, not the top of the stock and... CRUUUUNCCH as my v-bit is rammed into the ply....

Luckily it hadn’t damaged the v-bit and the area where it went into the wood is 20mm away from where my part is cut... but I had to run homing and set up the coordinates again... all because I changed my Z zero location.

But then, I don’t know what I did, all my macros and keymaps and other setting for UGS just went POOF! I have no idea how I did it. Luckily I keep a backup of the settings but then found out that the macros have to be backed up separately... and I hadn’t done so.

So all my routines (including the go to Z zero one that got me into trouble earlier) will need to be manually put in. Hopefully today will be better.