. .
Page 4 of 4 FirstFirst ... 234
  1. #31
    Following this thread as I've just started my conversion, mines a similiar spec to yours voyager1972. 6Kw HQD Atc spindle, ETH300 with UBB board & Uccnc controller...

    I had contemplated asking Dean at Jazzcnc if he does on site installation but he seems a busy guy...

  2. #32
    just make sure you have the motor parameters setup correctly in the vfd before running the spindle.

Page 4 of 4 FirstFirst ... 234

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Chinese VFD and 2.2Kw Spindle
    By JackDavies in forum Spindles & Drive Motors
    Replies: 6
    Last Post: 09-01-2019, 08:04 AM
  2. Chinese 300W DC spindle - is the spindle shaft grounded?
    By HankMcSpank in forum Spindles & Drive Motors
    Replies: 44
    Last Post: 26-11-2016, 07:25 PM
  3. FOR SALE: 1.5kw chinese spindle with VFD
    By discodave in forum Items For Sale
    Replies: 0
    Last Post: 17-06-2014, 07:05 PM
  4. WANTED: Chinese 1.5kw spindle/vfd
    By Philly in forum Items Wanted
    Replies: 5
    Last Post: 10-02-2013, 11:44 AM
  5. WANTED: Spindle holder for 1.5kw Chinese spindle.
    By jcb121 in forum Items Wanted
    Replies: 19
    Last Post: 14-10-2011, 02:07 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts