Thread: DIY PSU build query...
Threaded View
-
19-02-2020 #1
Hi,
I've been reading the following thread:
http://www.mycncuk.com/threads/11628...per-CNC-Router
and I've got a question regarding a DIY bulit power supply that is mentioned in post #9 and my question is regarding the current output....
Jazz recommends against using the Zapp Automation one (in post #8) as it maxes out at 6A, but from what I can tell the specs for the DIY version that is recommended and built using a 500VA 45V are exactly the same and it's output is 6A too.
The only 230V single primary that they (Rapid) sell is a 500VA one.
So my question is...
What kit/parts do people use if they want their DIY PSUs to provide more than 6A output? To enable future use of additional motors?
CheersLast edited by joe.ninety; 19-02-2020 at 02:20 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Mach 3 jogging query
By Stressedwoodman in forum Artsoft Mach (3 & 4)Replies: 6Last Post: 29-12-2018, 05:58 PM -
BF support bearing query
By Voicecoil in forum Lead Screws, Nuts & SupportsReplies: 2Last Post: 16-12-2018, 12:32 PM -
NEW MEMBER: Query:
By Rwright in forum New Member IntroductionsReplies: 0Last Post: 29-01-2018, 11:05 AM -
CNC newbie electronics query II
By Skydeals in forum General ElectronicsReplies: 4Last Post: 09-07-2014, 10:33 PM -
CNC newbie electronics query
By Skydeals in forum General ElectronicsReplies: 17Last Post: 08-07-2014, 06:06 AM
Bookmarks