New member looking for machine advice

[latza]

I havnt found a machine yet. I’m contemplating making one. I can fabricate and make things so that’s not a problem but I don’t know anything about the motors and drivers at all

Is there a fairly powerful motor kit with everything in that I can buy and bold to a table

I’d like to be able to fit a 8x4 sheet if possible

[JAZZCNC]

Hi Latza,

Strongly advise you to search around the forum and do some research before buying anything. The cheap machine kits you'll see are often not very good, same for kits of components, they nearly always have components that are not correct.

Building a machine isn't difficult if you are handy with tools and can fabricate but it does require planning and good understanding of what you'll need. Do the research before doing anything else and look at other build threads. Then start a build thread of your own and ask all your questions in that thread. This way when people look they can go back and see the whole story.

If you rush out and buy stuff without the research or no plan on machine design then you will 99.9% buy the wrong stuff.