How to setup Chinese AASD Servo electronic gearing

[eMTea]

Hi!
I know the thread is already a few years old, but hopefully you're still here :)

I wonder, my planned controller (UC300ETH-Max) is 400khz, and the servos are 1500rpms.

Is the 400khz divided for all simultaneously sent pulses to all moving axis, or a separate frequency for each axis output?

[JAZZCNC]

Hi!
I know the thread is already a few years old, but hopefully you're still here :)

I wonder, my planned controller (UC300ETH-Max) is 400khz, and the servos are 1500rpms.

Is the 400khz divided for all simultaneously sent pulses to all moving axis, or a separate frequency for each axis output?

The 400Khz is per axis output.