Threaded View
-
29-02-2020 #1
hey guys
my cnc machine started playing up by acting all random whilst doing auto tool zero. it would try to drive through the zero plate
or if stops on touching the plate it would go up, reach the limit and still try to force its way up. I had simular behaviour in the past,
so changed the Z motor cable. the problem remained. I changed the main board, problem stayed. I changed the stepper drive for
Z and suddenly i can't control directions for xyz manually at all. however, when in Mach 3 i tell it to go to home coordinates it does fine, if i execute
g-code it runs ok in all directions xyz. Any idea what could have caused the manual controls to be unresponsive.
I run this gear http://www.cnc1.eu/en/profi4-controller.htm
Thank you for any of your help.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CONVERSION: Bridgeport Manual to CNC conversion...
By Davek0974 in forum Conversion Build LogsReplies: 413Last Post: 05-04-2020, 08:07 PM -
CNC is unresponsive to x y z movenment manually
By eugeleb in forum Control Hardware & SystemsReplies: 0Last Post: 29-02-2020, 02:35 AM -
Manual lube oil
By alboy in forum General DiscussionReplies: 3Last Post: 22-07-2016, 11:02 PM -
WANTED: Centec 2A manual
By Web Goblin in forum Items WantedReplies: 0Last Post: 03-09-2012, 09:56 AM -
Translating the manual
By Robin Hewitt in forum Moulding MachinesReplies: 22Last Post: 01-09-2012, 01:21 PM
Bookmarks