Thread: NordicCNC's build log
Threaded View
-
03-03-2020 #9
Good points. A 2:1 ratio resulting in the ballscrew rotating with 1500rpm, I will have to go for either 2010 or 2510 ballscrews, and decrease the ballscrew length to about 1100-1200mm.. This will give me a safety factor of around 1.2 with fixed-floating bearings.
Seems ridiculous to have to use any larger diameter ballscrews. I have not seen anyone else using that here on the forum. How does everyone else achieve 15-20m/min?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
BUILD LOG: New Build - For Your Amusement - MK-2 build
By Karl in forum DIY Router Build LogsReplies: 12Last Post: 08-02-2017, 08:03 PM
Bookmarks