NordicCNC's build log

[NordicCnc]

Might be worth considering how you'll access some of these bolts.

Take for instance the front bearings on the gantry - does the rail being longer than needed foul adjusting those bolts?

The rails are not longer than needed. The X-axis can travel all the way to the end actually. The clearance between the rail and the block is 30mm, so I am quite sure there will be enough room. I need to double check this.

Does the servo on the back prevent access to the rear ones?

If you're trying to adjust the machine for gantry squareness, and you have to remove the servo between adjustments, that is going to get old fast.

I will have to look into this as well, hehe.

Thank you for the heads up!