Quote Originally Posted by NordicCnc View Post
Can you specify some of the bad things? But, yes I will most lilely go for these anyway. Many have used them with great success. The manual and software is really good (not chinglish!) There must be bad things about the Delta servos also.
It's been a while but it mostly related to the encoder's output from the drives when using with a controller that can fully close the loop. There were some timing issues that caused problems between controller and drive. But that was some time ago so they will have probably resolved that issue by now but I've seen all kinds of little things and conflicts on various forums etc.
But like you say Delta and other manufacturers do have there own issues as well and it's how they are resolved that matters most, DMM are very good in this respect I believe,