Threaded View
-
06-03-2020 #4
Last Activity: 19-01-2024
Erm, I've left my manual for Huanyang VFD at work but I've done enough of these now to know these are the main parameters to check and looked back at a few posts to verify.
Obviously make a note of the current settings before changing so can set back.
Pd04 = base frequency so need 50hz
Pd05 = Max freq so set this to the max you want to run this motor at ie: 100hz wouldn't go above that.
Pd08 = Max voltage set to 240V
Pd141 = rated volts set to 230V
Pd142 = rated current set to 2.74
Pd143 = # poles set to 4
Pd144 = motor speed set 1370
-
The Following User Says Thank You to JAZZCNC For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Servo motor and inverter dilemma
By dazp1976 in forum Motor Drivers & ControllersReplies: 2Last Post: 11-09-2018, 11:02 AM -
Last one of the 2017 Lathes - 1.5kW 3phase motor with inverter
By komatias in forum Manufacturer NewsReplies: 0Last Post: 02-01-2018, 10:56 AM -
Lenze 8200 VFD Inverter - Spindle motor not moving
By Fgc in forum Spindles & Drive MotorsReplies: 7Last Post: 13-11-2017, 02:34 AM -
Machine Slow on Curves
By swisscheese in forum Computer SoftwareReplies: 31Last Post: 12-04-2014, 12:49 AM -
Forum Slow
By pcstru in forum General DiscussionReplies: 3Last Post: 27-01-2011, 03:54 PM
Bookmarks