. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 24-10-2009 #1
    jonm's Avatar
    Location unknown.
    jonm
    Last Activity: 19-06-2011 Has been a member for 9-10 years. Has a total post count of 89.
    thanks john
    so my steps are set right , will try the settings you suggest, i knew i should be able to get a bit more speed somehow, if i can even get to 1000mm a min i will be happy
    Reply With Quote Reply With Quote
  2. 01-11-2009 #2
    jonm's Avatar
    Location unknown.
    jonm
    Last Activity: 19-06-2011 Has been a member for 9-10 years. Has a total post count of 89.
    managed to get my speed up , wired the steppers bipolar single coil
    at 2.5 amps the 3nm motors are down to about 2nm but the speed has increased quite considerably can get about over 1000mm/min
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Need to slow down a signal due to Safe Torque Off alarm
    By corkcnc in forum General Electronics
    Replies: 0
    Last Post: 04-06-2014, 11:35 PM
  2. Machine Slow on Curves
    By swisscheese in forum Computer Software
    Replies: 31
    Last Post: 12-04-2014, 12:49 AM
  3. HSM Advisor - High Speed Machining feed & speed calculator
    By magicniner in forum CAD & CAM Software
    Replies: 2
    Last Post: 20-01-2014, 12:57 PM
  4. Help! Steppers losing steps and making a racket under slow feed..
    By fasteddy in forum Stepper & Servo Motors
    Replies: 23
    Last Post: 06-08-2011, 03:03 PM
  5. Forum Slow
    By pcstru in forum General Discussion
    Replies: 3
    Last Post: 27-01-2011, 03:54 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules