Thread: KX3 Spindle Problem
Threaded View
-
14-03-2020 #3
Hi Jaz
Yes the 0-10v comes from the BOB in the right hand side electrical compartment and then goes to the DC spindle control board in the rear compartment. All the works are as the standard Sieg KX3. I'll take some photos and post them to-morrow.
Thanks
Ken
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Huanyang VFD and spindle problem - VI/GND drawing voltage from my controller
By Mr*Beaver in forum Spindles & Drive MotorsReplies: 6Last Post: 20-12-2018, 03:40 PM -
Seig C3 CNC spindle problem
By Leadhead in forum Machine DiscussionReplies: 11Last Post: 15-08-2018, 08:12 AM -
Huanyang VFD and spindle problem
By BriceO in forum Spindles & Drive MotorsReplies: 20Last Post: 07-08-2018, 08:56 AM -
Problem with Spindle not spinning
By Noplace in forum Spindles & Drive MotorsReplies: 4Last Post: 22-01-2016, 02:40 PM -
CNC spindle control VFD problem
By djc in forum Motor Drivers & ControllersReplies: 1Last Post: 13-09-2009, 09:26 PM
Bookmarks