. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 07-04-2020 #10
    Kitwn's Avatar
    Lives in Don, Tasmania, Australia.
    Kitwn
    Last Activity: 15-07-2024 Has been a member for 7-8 years. Has a total post count of 983. Received thanks 118 times, giving thanks to others 52 times.
    Quote Originally Posted by JAZZCNC View Post
    I think it is the speed control board, does it have a potentiometer on it.? I think the AP stands for Analog Potentiometer Board.
    The blue thing, top right hand corner of the photo is a trimmer potentiometer, possibly a multi-turn type. The label under it looks like "START/STOP". If you adjust it keep track of how many turns and in which direction so you can put it back where it was.

    Edit: Just made time to read Doddy's link. START/STOP is a label on one of the connectors. The potentiometer is for the speed at max control voltage. Pots can become faulty and go high resistance but it's possible to clean the track inside by simply adjusting it up and down a few times. Certainly worth a try for the time it takes.
    Last edited by Kitwn; 07-04-2020 at 09:59 AM.
    An optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Huanyang VFD and spindle problem - VI/GND drawing voltage from my controller
    By Mr*Beaver in forum Spindles & Drive Motors
    Replies: 6
    Last Post: 20-12-2018, 03:40 PM
  2. Seig C3 CNC spindle problem
    By Leadhead in forum Machine Discussion
    Replies: 11
    Last Post: 15-08-2018, 08:12 AM
  3. Huanyang VFD and spindle problem
    By BriceO in forum Spindles & Drive Motors
    Replies: 20
    Last Post: 07-08-2018, 08:56 AM
  4. Problem with Spindle not spinning
    By Noplace in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 22-01-2016, 02:40 PM
  5. CNC spindle control VFD problem
    By djc in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 13-09-2009, 09:26 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules