Inductive Limit Switch problem

[dazp1976]

You think it works well because you have nothing to compare it against.! When you get the new controller with higher pulse freq etc you'll see the difference.

Regards the N/O question then provided you use separate inputs then you can use different switch types. Obviously if wiring in series and sharing the same input they must all be the same type.

Also if your thinking to buy Warp9 ESS then I'd look at others like UC300 because they are better than ESS and you are not stuck with mach3/4.

Thanks. There's eperate connections for estop and each axis limits. 2 switches will be wired in series per axis.

In regard to the controller in the u.k. I can easily get an ESS or a UC400eth but the 400 has limited ports.
I've found a UC300eth-5lpt in Ireland and that's about it.

I'll still end up using the cheap boards on them though but that shouldn't matter too much, should it.