My sizes are out

[Desertboy]

I cut 11 indents they are all out by the same amount ~1mm but the distance between the indents is correct.



So the indent is 49mm and the distance between indents is 51mm. They should be 50mm each.

Over the 11 indents the distance is correct.

Set up 1/2" end mill (Brand new trend bit), pocket no stock to leave.

The top row the clamps weren't tight enough and slipped so cut the bottom row but properly clamped.

I looked through the DDCSV's settings and every tool offset was set to 0.0

[JAZZCNC]

Did you measure the tool.?