Me too! It's been a long time but we'll get there. I'm actually pretty glad I did the wiring aspect earlier, I think that the thought of tackling that again right now would be overbearing.

The top is drying well but not as flat as I would have liked, there is an area in the centre where the concrete is 5mm or so lower than the rest, I'm not entirely sure if it was bowing under the weight or just due to some factor related to drying but it's not the end of the world.

I have sourced the resin, it's here with me, I ended up going to a crowd in Northern Ireland but I'll fill in details later around that.

Prior to pouring the top I intend to flatten it as much as possible, reason being the resin isn't cheap and I want to have a nice even layer across the surface. To that end I have ordered a Diamond Cup for grinding/polishing concrete that will fit to my 4" grinder. It's on the way so should be here soon. It shouldn't take too much effort to knock down the high spots of the top with this tool to prepare it for the epoxy layer. I might combine the grinding with some filling of the very low area with epoxy/granite to minimise grinding but we'll see how we go.

I have a good respirator and will likely try to work wet with the grinding if possible, I know silicosis from breathing concrete dust is nothing to toy with. I really would have liked to have avoided grinding the top but those are the breaks, it will all work out I'm sure. As soon as the grinding disk arrives I'll be getting started.

One thing I'm a little concerned with in relation to the epoxy pour is the temperature in the workshop, looking at the resin data sheet we need to stay above 15 deg. C to avoid issues. I'll have to plan ahead with weather and some external heating source (heat lamp maybe) but I'll have a think, I'm sure we can come up with something.