Losing steps/position, again

[Doddy]

Interesting that "Modded" worked - that suggests your pulse width (somewhere in the motor tuning pages of Mach3 by memory) is less than 3uS. Try changing that to 5us for reliable operation.

EDIT: Silent?, Nonsense - you'll appreciate silent when you replace with a digital DSP controller.

[ngwagwa]

Interesting that "Modded" worked - that suggests your pulse width (somewhere in the motor tuning pages of Mach3 by memory) is less than 3uS. Try changing that to 5us for reliable operation.

They are all set at zero! Can I leave them for now and look at them when I go over to UUCNC?

[Doddy]

They are all set at zero! Can I leave them for now and look at them when I go over to UUCNC?

Your call.

I'll tell you the behaviour if the pulse width is too low... You lose steps.

[ngwagwa]

Your call.

I'll tell you the behaviour if the pulse width is too low... You lose steps.

Right I will change them when I go in tomorrow.