Thread: Losing steps/position, again
Threaded View
-
11-04-2020 #10
Here is the list:
Existing items
Power supplies:
24V 3A
24V 14.6A
12V 2A
RFI Filter
Omron relay MK2P-S
Omron relay G2R-2-SN
Control Transformer" with outputs marked 28, 110, 120 and 240
DIN Rail
Fan (voltage unknown will check tomorrow)
Main on/Off switch
On order:
Airlink 500VA 230v to 2x45v toroidal transformer
Power supply 50W 5V DC 10A
bridge rectifier 400V 35A
4OFF Electrolytic Capacitor, 4700 µF, 100 VDC
ABXX-E Motion Controller
3-OFF Stepper Motor Driver 6.0A, 80V CNC Microstepping CW8060
Terminal Blocks and wires
I am pretty sure I can wire the ABXX to the drivers and steppers and the VFD is seperate so really all I need help with is getting the mains to the PSUs and on to the devices and the E-Stop.
I think I can work out the limit switches.
I thought it would be tidy to use the existing connectors on the rail to get my rectified output from the toroidal transformer the the drivers, I could have the wiring run behind my mounting board.
Obviously if I have missed anythng please let me know.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Losing steps
By Edendale in forum General DiscussionReplies: 11Last Post: 06-03-2020, 10:10 PM -
Weird noise on travel and losing position
By ngwagwa in forum Artsoft Mach (3 & 4)Replies: 12Last Post: 07-02-2020, 05:45 PM -
Router losing steps. Solution needed. Will this help?
By cncbobuk in forum Chinese MachinesReplies: 9Last Post: 27-12-2017, 03:40 AM -
Losing steps on Z axis
By Arzo10 in forum Machine DiscussionReplies: 15Last Post: 31-03-2017, 10:49 AM -
New Mill losing steps
By lukecnc2012 in forum Gantry/Router Machines & BuildingReplies: 42Last Post: 08-11-2014, 02:56 PM
Bookmarks