Thread: AXBB-E any opinions?
Hybrid View
-
09-04-2020 #1
Last Activity: 21-09-2020
My machine is currently using one. The biggest issue with it was wiring the stepper motor signals....the unit does not have enough common terminals. Other than that its not too bad :)
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AXBB charge pump fault
By CharlieRam in forum CNCdrive (UC100, UC300ETH)Replies: 78Last Post: 18-07-2021, 08:31 PM -
Help needed to connect my VFD to the AXBB controller
By CharlieRam in forum Spindles & Drive MotorsReplies: 24Last Post: 23-09-2020, 12:10 PM -
correct wiring sizes for JMC Servo iHSV57-30-18-36-21 with axbb-e controller
By the great waldo in forum General ElectronicsReplies: 18Last Post: 31-01-2020, 11:58 PM -
AXBB-E licence key problem
By Voicecoil in forum CNCdrive (UCCNC)Replies: 15Last Post: 26-01-2020, 02:22 PM -
CNCDrive AXBB super deal?
By driftspin in forum CNCdrive (UC100, UC300ETH)Replies: 18Last Post: 16-03-2019, 10:10 PM
Bookmarks