Thread: moving from Mach3 to AXBB
Threaded View
-
11-04-2020 #6
Last Activity: 03-12-2020
Cheers Doddy.
Regarding the post processor I have had to write my own (you can probably guess why) and I haven't used and G28s (yet). In demo mode UCCNC looks like it runs my gcode OK but my first cuts will be in kingspan just to be on the safe side.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AXBB-E any opinions?
By ngwagwa in forum Motor Drivers & ControllersReplies: 12Last Post: 21-07-2021, 04:32 PM -
Help needed to connect my VFD to the AXBB controller
By CharlieRam in forum Spindles & Drive MotorsReplies: 24Last Post: 23-09-2020, 12:10 PM -
AXBB-E licence key problem
By Voicecoil in forum CNCdrive (UCCNC)Replies: 15Last Post: 26-01-2020, 02:22 PM -
CNCDrive AXBB super deal?
By driftspin in forum CNCdrive (UC100, UC300ETH)Replies: 18Last Post: 16-03-2019, 10:10 PM -
moving mach3 help please
By h4ppy-chris in forum Artsoft Mach (3 & 4)Replies: 12Last Post: 07-03-2011, 07:33 PM
Bookmarks