Quote Originally Posted by Clive S View Post
I would have thought that this SHOULD have some effect as have been mentioned way back in the post like runaway.

I don't know your drives, you mention cat5 do the drives have a RJ45 connector or hard wired ? I have seen many times that using the RJ45 with crappy plugs the pins don't always connect.

Keep at it you will get there.
Yes, two RJ45. One for the encoder connection and one to the motion controller. Just to add another potential issue, it has a differential line driver, which from what I understand converts single ended to differential signals. The encoder is hard wired to the line driver which then has an RJ45 plug on the other end which then goes to an RJ45 on the motor driver.

I also made up all of the cables with the RJ45 plugs on, I did test them all before installing them but I guess that might not be a bad place to start looking for bad connections as well.

The only major change I made from when it was running was the encoder wiring, so I'm hoping its something silly like a bad connection!

Thanks for the help guys, I'll get stuck into it again tonight and see what I can find.