Threaded View
-
15-04-2020 #1
Hi people I have a question.
When joining stepper motor and proximity switch wire to CY cable what is best practice to doing this?
Is it reasonable to use junction boxes with wires from the stepper motors and proximity switches joined to CY cable or is it better to just join the wires together by twisting and heat shrink and then just sliding them into the cable / drag chain?
Thoughts about this would be greatly appreciated
Regards... Chris
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Roller Boxes
By magicniner in forum Workshop & EquipmentReplies: 0Last Post: 07-06-2018, 07:40 PM -
Project Boxes
By dfox1787 in forum General DiscussionReplies: 0Last Post: 16-05-2018, 04:59 PM -
Where Do The Wires Go ?
By Kev2960 in forum Chinese MachinesReplies: 10Last Post: 25-02-2017, 08:49 AM -
Joining or "but joining" linear rails
By CNCBlug in forum Rails, Guideways & BearingsReplies: 5Last Post: 09-10-2014, 08:56 AM -
voltage on motor wires
By phill05 in forum General ElectronicsReplies: 9Last Post: 11-02-2012, 03:43 PM
Bookmarks