. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 15-04-2020 #3
    Voicecoil's Avatar
    Lives in South Lakeland, United Kingdom.
    Voicecoil
    Last Activity: 07-11-2023 Has been a member for 6-7 years. Has a total post count of 609. Received thanks 87 times, giving thanks to others 14 times. Referred 1 members to the community.
    Quote Originally Posted by AndyUK View Post
    I would strip the wires at both ends, solder and then heatshrink each individual wire, before bringing the shielding back up and over as much as possible then heatshrinking over that.
    I did this on a number of cables on my machine where there wasn't room for a junction box to good effect - I used adhesive lined heatshrink for the overall cover. Just be careful to visually inspect every joint before covering with heatshrink.
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to Voicecoil For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Roller Boxes
    By magicniner in forum Workshop & Equipment
    Replies: 0
    Last Post: 07-06-2018, 07:40 PM
  2. Project Boxes
    By dfox1787 in forum General Discussion
    Replies: 0
    Last Post: 16-05-2018, 04:59 PM
  3. Where Do The Wires Go ?
    By Kev2960 in forum Chinese Machines
    Replies: 10
    Last Post: 25-02-2017, 08:49 AM
  4. Joining or "but joining" linear rails
    By CNCBlug in forum Rails, Guideways & Bearings
    Replies: 5
    Last Post: 09-10-2014, 08:56 AM
  5. voltage on motor wires
    By phill05 in forum General Electronics
    Replies: 9
    Last Post: 11-02-2012, 03:43 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules