. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 18-04-2020 #7
    cropwell's Avatar
    Lives in Nottingham, United Kingdom.
    cropwell
    Last Activity: 28-05-2023 Has been a member for 9-10 years. Has a total post count of 1,646. Received thanks 170 times, giving thanks to others 30 times.
    I would remind you that all wires should be securely held down with cable ties or P-clips to stop the joins flexing. Movement at joints is the most likely place for failure.

    Cheers,

    Rob
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to cropwell For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Roller Boxes
    By magicniner in forum Workshop & Equipment
    Replies: 0
    Last Post: 07-06-2018, 07:40 PM
  2. Project Boxes
    By dfox1787 in forum General Discussion
    Replies: 0
    Last Post: 16-05-2018, 04:59 PM
  3. Where Do The Wires Go ?
    By Kev2960 in forum Chinese Machines
    Replies: 10
    Last Post: 25-02-2017, 08:49 AM
  4. Joining or "but joining" linear rails
    By CNCBlug in forum Rails, Guideways & Bearings
    Replies: 5
    Last Post: 09-10-2014, 08:56 AM
  5. voltage on motor wires
    By phill05 in forum General Electronics
    Replies: 9
    Last Post: 11-02-2012, 03:43 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules