Thread: probe setup ?
-
18-04-2020 #1
i am in the middle of an upgrade from a xhc mkv chinese controller to the cncdrive uc300eth lpt5 controller and ucbb-1 breakout board,,, i am lookin advice with the probe setup,,,,the probe has two wires which are coming from the drivers,,,,one wire runs to the top of the gantry where it connects to a cable with the probe and is also grounded to the machine body,,,i am not sure how to connect the other wire to the bob,,,
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CNC first setup homing
By Gary1329 in forum General DiscussionReplies: 1Last Post: 30-07-2019, 11:40 PM -
Edge Probe + tool length probe on same input
By Noplace in forum General ElectronicsReplies: 1Last Post: 18-06-2016, 11:12 AM -
5 axis setup
By Blackrat in forum General DiscussionReplies: 0Last Post: 12-09-2015, 06:56 PM -
Z-Axis setup
By Yaser in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 18-12-2014, 10:26 AM -
FOR SALE: 4th axis setup
By johngoodrich in forum Items For SaleReplies: 4Last Post: 13-06-2012, 06:17 PM
Bookmarks