. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 16-04-2020 #2
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    It's been a while since I used one of these but I seem to remember they needed a 5v supply for the charge pump or a jumper setting on the board to disable it. So check the board and there will be 3pins together if I remember correctly with 5V and EN and Gnd. Put a jumper across 5V & EN pins if there isn't one there already and it will disable the charge pump.
    If the board doesn't see 5V across these pins it will disable the outputs which is probably why it's not moving.

    Or you can just put 5v+ on the EN pin and it keeps the charge pump in place then if you lose 5v the outputs get shutdown. Your choice.
    Last edited by JAZZCNC; 16-04-2020 at 11:27 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. New CNC build gantry questions
    By Capsuna in forum Gantry/Router Machines & Building
    Replies: 8
    Last Post: 04-12-2019, 12:59 AM
  2. BUILD LOG: 1800 x 1500 x 500 work area CNC build log
    By marbles in forum DIY Router Build Logs
    Replies: 9
    Last Post: 17-10-2018, 01:53 PM
  3. Beginner MYCNCDIY Mill Build questions
    By suraj1793 in forum Gantry/Router Machines & Building
    Replies: 35
    Last Post: 15-11-2014, 06:28 PM
  4. A few questions before I start my build
    By eclassic in forum General Discussion
    Replies: 0
    Last Post: 11-07-2011, 10:54 PM
  5. NEW MEMBER: Hi from rainy York - build plans/questions
    By bikepete in forum New Member Introductions
    Replies: 13
    Last Post: 11-10-2009, 07:43 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules