Lathe Reverse

[driftspin]

Hi,

After seeing the documentation sheet I do not think your motor is like the schematics I posted earlier. Is it the sheet from your motor?

I think you might have been right then, if no one has been playing with the motor wiring and bus bars before you took the picture.




Grtz Bert.

Verstuurd vanaf mijn SM-A505FN met Tapatalk

[blackburn mark]

Hi,

After seeing the documentation sheet I do not think your motor is like the schematics I posted earlier. Is it the sheet from your motor?

I think you might have been right then, if no one has been playing with the motor wiring and bus bars before you took the picture.




Grtz Bert.

Verstuurd vanaf mijn SM-A505FN met Tapatalk

No, its not my document, it is one that looked like many others with the bus bars but I'm pretty sure its not how mine is wired.
The motor looked like it had been messed with a bit but it ran ok in forward.....

I am half way through rewiring it for a simple capacitor pin swap but its getting a bit tight in there so might have to surrender and pull the motor out.

[blackburn mark]

My hypothesis has failed under test :(



My confidence with logic is fooked!
I can get it to work in reverse under some strange setup that I cannot get a clear perspective on.... its back to the drawing board.