Hi all,

Amateur here from near Huddersfield in Yorkshire. I have a mill from Axminster that I converted to CNC probably about 10 years ago. It was working ok but I've moved a couple of times since then and it probably hasn't run for about 6 years. It used to run on a PC with LinuxCNC and a 4 axis TB6560 board via the parallel port. With the lockdown in place I've been spending some time trying to get it running again, but
a) The PC motherboard is dead
b) The hard drive it dead
c) The driver board blew up

So.... I bought a TB6600 board a couple of years ago and I'm finally trying to get it running with a Raspberry Pi. I can't get the board to do anything so I am joining here to see if anyone can help. I'm off to post in the controllers forum now..

Cheers,
Kev.