Hybrid View
-
23-04-2020 #1
Clive - All files are in linuxcnc/configs/sheetcnc
Kitwin/Cropwell - yeah I tried what he did on the video but no joy. Re' the linuxcnc forum, I thought it best to try and wind everyone up at the same time, either that or I hoped someone might have some help. You never know unless you try!
I will try and get a picture of my wiring setup in an hour or so. All the dip switch settings etc have been copied over at the linuxcnc forum if you were interested.
Thanks for the continued help.
-
23-04-2020 #2
I spent 33 years as a programmer, specialising in IBM360 seriesFTP-ALCP, which is pretty much professional nerd level, but I can't get into Linux, made by nerds for nerds with time on their hands as far as I am concerned. Creating esoteric problems for esoteric solutions.
Best of Luck !
-
24-04-2020 #3
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Auto-Squaring with LinuxCNC v 2.8
By Kitwn in forum LinuxCNC (EMC)Replies: 12Last Post: 25-04-2021, 01:25 AM -
NEW MEMBER: LinuxCNC using EtherCAT anyone doing this?
By Brassneck in forum New Member IntroductionsReplies: 1Last Post: 01-08-2019, 11:12 AM -
What do I need to run LinuxCNC???
By gatesy in forum LinuxCNC (EMC)Replies: 22Last Post: 02-12-2015, 07:42 PM -
Mach3 vs LinuxCNC/EMC What do you use and why?
By Lee Roberts in forum Machine Control SoftwareReplies: 46Last Post: 26-11-2013, 01:02 AM -
How many LinuxCNC/EMC users do we have?
By birchy in forum LinuxCNC (EMC)Replies: 16Last Post: 30-12-2012, 08:08 PM
Bookmarks