Quote Originally Posted by Chip Owner View Post
And in such a childish response, your reply confirms my summation of your arrogance, ignorance and nastiness.
Ok well nowhere in any of my posts have I thrown insults or attacked you personally, so who's the nasty one here.?

Regards the Armchair warrior bullshit then I've built or converted more machines and helped or influenced more builds all over the world than you've probably cut parts on your new toy so you couldn't be further from the mark on that one.!

If you care to look back you'll also see that nowhere did I condemn the machine and actually agreed with you that it's suitable for cutting aluminum sheet stock.
My comments were and are still aimed at those who think it's capable of cutting thicker aluminum as they see done on more substantial machines.

Now what you don't know is that I've had over a dozen PM's or Emails asking about this machine from people who want to do exactly this, so this was the main reason for my comments when I saw your post which said "This machine can cut aluminum all day long". . . .Because as I said in one of my replies there's a big difference between cutting sheet stock and plate correctly and this machine isn't strong enough to cut plate stock correctly with a good finish and this needs pointing out to those potential purchasers.
Anyone who's built low strength machine and tried to cut plate with any reasonable DOC and to a decent finish quality will verify this, of which there are many on this forum.! . . . Most of who built a stronger better-suited router to do the job.

Now enjoy your new money tree and have a nice day.!! ..