Hi all.
Please excuse if not the right forum category.

I am looking to get a price for an initial bit of small cnc work.

Essentially, I am looking for someone with very accurate work, to be able to route the following:
1. Frame edging on left hand side (swirls, curves from 1-4 mm wide and 4 mm deep)
2. A rectangle 5mm deep at 6x4"
3. An inner portion of the same rectangle, 7mm deep leaving a 4mm lip around the edge
4. A cross (crucifix) approximately 20mm wide, 7mm deep
5. A selection of words:
Line 1: Congratulations
Line 2: (Persons name) up to 22 letters
Line 3: Christened today
Line 4: Date in following format 11-05-2020

See attached sketch.

Product is made from 30mm glued Cedar boards 450mm x 210mm planed and smoothed to 500 grit.

Am looking for costs and if acceptable, will be asked to produce the work for each of our orders