Thanks for the Info Jazzcnc. Those steppers and drivers sure look good. Perhaps a little outside what I was looking to spend so I may save the penny's and get them in a couple of months. I need to get the machine in working order first off so I will use the steppers that I have for the moment and upgrade them at a later stage. The UC300 Ethernet looks good and I will order one of those today and a BOB.Thanks for the tip as I was going to get a usb device. They seem like a lot of trouble from what I have read so far.

At the moment I will concentrate on the mechanical side of things and get her limping in order to produce some parts for the future build.

Thanks again for all the info :)