UC300ETH, UCCNC and BOB ordered and on the way !!!!!!!!!!!!!!. Pretty hard to get anywhere that has stock of them. I ended up going to the Netherlands! (Virtually).

Took the plunge and ordered some HGR Square rail and carriages also My old setup was using round supported rail. Never had any issue with it as my gantry weighed in excess of 70KG. Gravity assist kind of kept things from floating around :) Ooh and emmm some 20mm Ballscrews and bits n Bobs... The 16mm Ballscrews that I had were a bit too short for what I needed.

Dam it anyway.. I promised myself I would not spend any dosh on this re-make of the Big girl. 1k out the door so far and those motors that Jazz sent me the link too will pop another 1500 or so out there too including mounts couplers etc. Once you get the CNC building fever it's hard to stop!!! Now if I could only get this idea of ATC out of my head I might be able to sleep ha ha. Last but not least the 4th and 5th axis. My biggest challenge will be keeping all of this from the missus!!!!!!