Hybrid View
-
22-05-2020 #1
Yeah. I'm happy enough with the 0.025mm I got it to. It's took me a long time of taking it apart, tweaking and rebuilding. The amount of thin alu foil shimming everywhere is ridiculous!!! lol.
The machine is over travelling a bit on proper calibration.
I've been cutting a few 300x150mm squares and they've actually been coming out at 299.98x148.98mm. I'll leave it at that
I won't need to go over 400x180mm in size so I add extra onto the edges of drawings. I'll leave it there as being within +/- 0.05mm for anything is good enough for me.
I do still need to work on the head. I need to make a spacer for it that's 0.14mm difference from end to end to bring it more square. I've got the column tilted atm. It's level with the table but not as it lifts and lowers. There is also still an issue with X where the screw mounts aren't perfectly straight with it. This is causing a tilt in the table as it travels full length so I'm limited to 300 of the 500mm available.
Yes I've had accidents with crashing dial indicators and there's stil loads of tweaking to do.Last edited by dazp1976; 22-05-2020 at 06:26 PM.
-
I've been cutting a few 300x150mm squares and they've actually been coming out at 298x148mm. I'll leave it at that..Clive
The more you know, The better you know, How little you know
-
22-05-2020 #3-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
-
22-05-2020 #4
-
22-05-2020 #5-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
-
22-05-2020 #6
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Cutter accuracy
By Neale in forum Tool & Tooling TechnologyReplies: 21Last Post: 02-09-2017, 03:23 PM -
Cut depths and spindal speeds to improve finsh time
By Fivetide in forum Tool & Tooling TechnologyReplies: 23Last Post: 21-05-2015, 08:39 AM -
Improve Kress TIR or get an upgrade?
By Hauk in forum Kress Milling MotorsReplies: 3Last Post: 23-02-2014, 06:18 PM -
trying to improve my board game
By cubikoman in forum General DiscussionReplies: 28Last Post: 12-05-2012, 06:57 AM -
NEW MEMBER: cubikoman needs to improve quality of his boardgame
By cubikoman in forum New Member IntroductionsReplies: 2Last Post: 16-02-2011, 12:17 PM
Bookmarks