Threaded View
-
08-06-2020 #15
Last Activity: 04-08-2022
Ok fair enough. I might still get some as I would like to go closed loop and I can run them at higher DC voltage than I am at the moment anyway. Currently at 68vdc but could get them up to 90 to get a bit more oomph
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CONVERSION: Weiss VM32 Mill Conversion
By picclock in forum Conversion Build LogsReplies: 18Last Post: 07-08-2019, 11:27 PM -
CONVERSION: Warco WM18 Mill Stepper motor advice
By Gotty101 in forum Conversion Build LogsReplies: 7Last Post: 18-08-2018, 05:06 PM -
Stepper motor selection, lower inductance vs holding torque
By smeg up in forum Stepper & Servo MotorsReplies: 3Last Post: 20-01-2015, 02:43 AM -
Weiss WMD25LV mill
By Bill K in forum Milling Machines, Builds & ConversionsReplies: 4Last Post: 29-06-2014, 12:52 PM -
EXPERIENCE: corkcnc ... a short tale
By purpose in forum Trading Experience & FeedbackReplies: 0Last Post: 29-12-2013, 04:43 PM
Bookmarks