Yes there is an error in the manual for the pin outs to the motors but the board silk screen is correct on my board as supplied.

My board came with a parallel cable for the PC and it seemed to all work after configuring the I/O on Mach3 to the settings that came in the chinglase manual! The problem I found was that the DIP settings for the microsteps was not correct. The 1/8 step was reversed with 1/16, a fairly minor problem but still irritating as I had a scaling error on movement until I figured it out.

I managed to buy the correct 2 mm spacing headers and crimps for the limit and eStop input on these boards if anyone is interested. I have a few spare that I can post at mininal cost.

John