Hello,

after i did not get response from cnczone i´ll try my first port here:

first problem first post:

I got the board from ebay (seller prettyworthshop)....

I connected the board to power supply with was included. The boards gets 24V - i measured that with a meter.

I connected the board to computer (LPT is set to ECP). I set all the MACH 3 parameters according to the manual (Signal in, Signal out, Motor....)

On the board itself we have 3 LEDS for which show when signal is available for axis movment. If i press cursor in MACH the middle LED (Y) glows only a bit. Above the 3 LEDS there are two LEDS and the right one is on all the time when i connect the parallel cable with the board. When is disconnect, the LED goes out.

The fan is not turning. Motor is connected but not moving...

I don´t know whats the problem. Can somebody help me ?

I hope to get this first problem soved with your help.

By the way - i built the MDF CNC Machine from buidyourcncDOTcom. I want to use tha machine for milling panels for my DIY 737-800 Homecockpit...

Cheers from Wuerzburg Germany

Andy