eBay TB6560 Stepper Motor Driver Boards

[Tenson]

I doesn't seem to be any of those! Body length is 53mm, phase resistance is 1.4R and phase inductance is 1.9mH.

I found that when I set the current limit switch to 100% it ran worse.

I could increase the voltage to the board. The motors nor board run hot. Is it safe to do so, and should I make that mod listed earlier - http://www.mycncuk.com/forums/showth...ll=1#post19305

[russell]

Did you measure the body length including the boss? If so it should be 51 mm and is probably a 57BYGH51-602A and produces 100 oz.in (about 0.7 N.m) at 2 A. Your resistance and inductance figure aren't a mile off considering the quoted tolerances.

I know the voltage rating is higher than 24 V but, considering the reliability (or lack of it) of these boards I would be nervous of doing so. Some of the mods suggested on various sites are decidedly dodgy!

Russell.

[Tenson]

Did you measure the body length including the boss?

Russell.

Nope, excluding like the diagram.