Fuling DZB200 Inverter

[dougie8]

Thanks Jazzcnc, I was getting a bit confused by the previous guys replies as the inverter was still fitted and wired into the BOB in the machine when I took delivery, the pervious owners had only disconnected the spindle.

very much appreciated

[JAZZCNC]

Ok I've just looked at the manual and I remember the parameter that sorted my issues was F1.0 I can't remember what it's set too but this was the game changer parameter so try changing it to 0 or 1 and see what happens. I think you need to restart the VFD for changes to take affect.

[dougie8]

Hi this was set at 2, I've tried both 0 & 1 still no joy

[Clive S]

deleted

[MarshaJusa]

From what I'm seeing the VFD model you have is designed for three phase to three phase... The R, S, T terminals are for three phase, if it were designed for single phase input it would have L and N.

Marsha

[Clive S]

From what I'm seeing the VFD model you have is designed for three phase to three phase... The R, S, T terminals are for three phase, if it were designed for single phase input it would have L and N.

Marsha

That is not correct. There are plenty of these inverters that has a three phase input and you can use any of the three phases to connect the single phase to.
IE. R,S or R,T

[JAZZCNC]

From what I'm seeing the VFD model you have is designed for three phase to three phase... The R, S, T terminals are for three phase, if it were designed for single phase input it would have L and N.

Marsha

No It's not. All the Fulling VFD's and many of the other Chinese VFD's come with R S T inputs and you just connect to any 2 of them for Single phase. They also accept 3 phase input.
I have just fitted the same VFD to single phase supply.