Threaded View
-
09-06-2020 #2
Last Activity: 4 Hours Ago
The WM 18 has a gas spring in it, have you checked yours.
What size motors and what micro steps are you using have you put a belt reduction on the motors. I have done two conversions with the WM18 but used ball screws with nema 23 3.1Nm and linuxcnc..Clive
The more you know, The better you know, How little you know
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Weird noise on travel and losing position
By ngwagwa in forum Artsoft Mach (3 & 4)Replies: 12Last Post: 07-02-2020, 05:45 PM -
motor making noise but not spinning
By dek667 in forum Spindles & Drive MotorsReplies: 0Last Post: 03-08-2018, 02:47 PM -
Denford Triac Spindle making an odd noise. Bearings at fault?
By Lieutenant Swarf in forum Denford MillsReplies: 12Last Post: 21-04-2018, 05:23 PM -
Knocking noise from stepper motor
By PWD in forum Stepper & Servo MotorsReplies: 0Last Post: 21-06-2015, 02:41 PM -
Dell monitor making a funny noise !
By Lee Roberts in forum MonitorsReplies: 1Last Post: 13-09-2013, 12:11 PM
Bookmarks