Threaded View
-
12-06-2020 #6
Last Activity: 15-07-2024
I've been using these drivers on my CNC router at 36V for a couple of years now without any problems.
Kit
https://www.omc-stepperonline.com/di...or-dm542t.htmlAn optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Tips for beginner with small gantry engraver
By Richard in forum Gantry/Router Machines & BuildingReplies: 0Last Post: 15-10-2018, 10:30 AM -
Rebuilding gantry
By kjetor in forum Gantry/Router Machines & BuildingReplies: 0Last Post: 11-05-2018, 10:38 PM -
BUILD LOG: Desktop type router - Fixed gantry - steel frame MK2
By Tom J in forum DIY Router Build LogsReplies: 14Last Post: 02-01-2017, 09:32 PM -
Engraver advice needed
By Rustynut in forum General DiscussionReplies: 5Last Post: 11-11-2016, 07:28 PM -
Designing a Gantry type concert router
By Jazmal in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 09-01-2015, 05:52 PM
Bookmarks