Threaded View
-
13-06-2020 #10
Last Activity: 19-01-2024
Ok well your motor tuning is setup for imperial.!
Originally Posted by chillybo
To set up correctly you need to know the screw pitch and the micro-steps set on drives. Divide the micro-steps by the pitch and this is your steps Per setting. If you have any ratio on the motor then you'll need to factor that in as well.
The velocity and acceleration you will have to set according to the machine by adjusting until motors stall then back them off 25%. Vel =2000 Accel=500 is a good starting point if you are unsure. If a router can't do those speeds it's not much use as a router.!!-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
-
The Following User Says Thank You to JAZZCNC For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Proximity limit switch problems
By davrich in forum General ElectronicsReplies: 16Last Post: 12-03-2018, 01:58 PM -
3 pin npn LJ12A3-4-Z/AX proximity switch help
By RobC in forum General ElectronicsReplies: 4Last Post: 14-08-2017, 07:50 PM -
3 wire proximity switch help
By mikem in forum General ElectronicsReplies: 24Last Post: 06-10-2015, 03:24 AM -
Proximity switch NPN or PNP
By Matt81 in forum General ElectronicsReplies: 9Last Post: 19-04-2014, 11:38 AM -
FOR SALE: Z axis with Home/limit switch and Nema 23 3nm
By Shinobiwan in forum Items For SaleReplies: 6Last Post: 02-02-2013, 10:54 AM
Bookmarks