CNC mach spindle not spinning

[Doddy]

Bernard - just a cautionary note - I'd personally review the controller settings before following the instructions to configure - one of the first program settings resets the controller to factory - so you would lose any pre-configuration by the OEM. Perhaps review the settings and get them copied down somewhere useful. The post from Cropwell - I'd seen it earlier but was a bit nervous of the reference to 110V operation - so proceed with care.

[cropwell]

The post from Cropwell - I'd seen it earlier but was a bit nervous of the reference to 110V operation - so proceed with care.

I share your apprehension. I don't know how VFD specific the parameter settings are. I know that some manufacturers deliberately go against de-facto standards (in other areas of electronics). I would recommend trawling through the settings to note down what the OEM set them to and compare with the list I found.