Okay quick update...

Got Alphacam loaded onto laptop, I'm using a usb to rs232 adapter to connect with the controller.

Simple rectangle in Alphacam...post processor (rye qmaxi Osai TC multidrill)... to Output nc.

Asks for X datum=0, then y datum=0 then tandem load - no.

Open in alphaedit and send to machine.

Machine accepts file and it shows in memory.

Start job.....stops....

I'm then getting X axis has exceeded limit...

Is this a noob error?

If only I had the Omicron 3000 controller manual....

Try again tomorrow

Sent from my Mi A1 using Tapatalk