Threaded View
-
01-08-2020 #37
If you don't want to shell out for a new post processor and you aren't so deeply immersed in an existing CAD/CAM system and control software then might I suggest you take a look at LinuxCNC?I believe Fusion has a post processor that will work with it and I know that Freecad does because thats what I use.I have to admit that I have seen Vectric software and it definitely goes it's own way with terminology and general approach.It does work and it isn't hugely expensive,but either Fusion or Freecad will do the job at zero cost.
Thread Information
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)
Similar Threads
-
NEW MEMBER: NEWBIE(ISH) with a RYE Quantum QM2515
By BEACHBLANKET in forum New Member IntroductionsReplies: 8Last Post: 18-07-2020, 01:22 AM -
BUILD LOG: belt drive to ballscrew drive changeover advice required
By marbles in forum DIY Router Build LogsReplies: 4Last Post: 14-02-2020, 02:14 AM -
Drive pulley size, Y drive redesign
By threedee in forum Belt Drive, Pulleys & TimingReplies: 7Last Post: 01-08-2019, 10:56 PM -
Bridgeport Romi EZ Path S - Axis Drive Fault
By Nemo1966 in forum Machine DiscussionReplies: 0Last Post: 12-02-2018, 01:13 PM -
fixed one fault, not i have a second
By terry1956 in forum CAD & CAM SoftwareReplies: 0Last Post: 17-02-2016, 08:34 PM
Bookmarks