SORTED IT OUT!!....

Now to figure out why my gcode is missing the head down and spindle speed and head up stop??

START
'(SQUAREALANDECPOST)
'(COMPONENT DATUM POSITION X = 0)
'(COMPONENT DATUM POSITION Y = 0)
N1 G71
N2 M51 H1S-
N3 M52D-
N4 M51 H2S-
N5 M5
N6 M51 H3S-
N7 M5
N8 M51 H4S-
N9 M53D-
'(OP 1 FINISH PASS TOOL 22 BALL END - 5MM)
'(EFFECTIVE DIAMETER 4.899)
N10 M06 T22
N11 G0 Z50
N12
N13 G0 Z50
N14 S100
N15 G0 X260.7 Y580.9
N16 G0 Z25
N17 G1 X260.7 Y580.9 Z-2 FX24
N18 G1 X434.91 Y580.9 FX48
N19 G1 X434.91 Y819.25
N20 G1 X260.7 Y819.25
N21 G1 X260.7 Y580.9
N22 G0 Z50
N23
N24
N25 M2

Obviously a mistake i'm making in ALPHACAM prior to sending to NC.....

Vectric Aspire looks so much easier to use!!!

If only there was a post processor for my machine!!!