Kit's Machine

[JAZZCNC]

If all else fails, read the instructions.

I'd forgotten Port 1 pinO1 on the AXBB-E is for the charge pump. Fingers crossed that turns out to be the only problem and a switch to pinO2 will bring the spindle to life.

One more thing which can be different from what the manual says is the analog voltage might be set to 10V rather than 5v.? The manual says the default is 5v but the last 20 controllers we have just fit have been set to 10V by default.

[Kitwn]

One more thing which can be different from what the manual says is the analog voltage might be set to 10V rather than 5v.? The manual says the default is 5v but the last 20 controllers we have just fit have been set to 10V by default.

Thanks Dean,
At present I just want to start the spindle by energising a relay as before, hence the use of an isolated output as described in section 9.1.1 of the AXBB-E manual, but I do plan to implement analogue speed control in the future. Presumably I'll need a properly organised tool library to make the most of that.

Kit