Thread: Spindle pulses on shutting down.
Hybrid View
-
21-08-2020 #1
Last Activity: 11-02-2024
Shutting down sequence has been
1 computer
2 power supply to panel
3 All power inc vfd
I have a spur which supplies the no volt relay to the Control panel, but separately supplies the 5 v PSU for the BOB. Will try taking its supply via the NVR.
Problem only became apparent when I added spindle control . BOB relay is only switching a 24v signal to the VFD
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Chinese 300W DC spindle - is the spindle shaft grounded?
By HankMcSpank in forum Spindles & Drive MotorsReplies: 44Last Post: 26-11-2016, 07:25 PM -
Basic 540 CNC. Motors skipping pulses?
By Skydeals in forum General ElectronicsReplies: 3Last Post: 18-10-2014, 06:56 PM -
TB6560 controller Runs spindle on power up When Mach3 plunges spindle stops
By RoyT in forum Spindles & Drive MotorsReplies: 5Last Post: 29-09-2014, 02:42 PM -
CNC Spindle Repair and Spindle Replacement for any Machine of any Manufacturer
By spindeldoctor in forum Manufacturer NewsReplies: 0Last Post: 13-11-2013, 07:50 PM -
G-Code into stepper driver pulses?
By HankMcSpank in forum Computer SoftwareReplies: 5Last Post: 09-01-2010, 12:55 PM
Bookmarks